Installing Your Link 105; Configuring A Bluetooth Connection With Webfleet - TomTom LINK 105 Installation Manual

Installing your LINK 105

There are two steps to setting up your LINK 105:
1. Configure a Bluetooth connection between your LINK 105 and your LINK 5xx/4xx.
There are two ways to establish a Bluetooth connection between your LINK 105 and your LINK
5xx/4xx:
By configuring a Bluetooth connection with WEBFLEET

By configuring a Bluetooth connection with the Activation Tool

Make sure you have properly noted and entered the Bluetooth address of your LINK 105,
which you can find on the label on the OBD-II plug.
2. Install your LINK 105 in your
Important: If the LINK 105 has been used in another vehicle before, you need to
before you start the engine of your vehicle, otherwise the calculation of the fuel consumption may
be incorrect.

Configuring a Bluetooth connection with WEBFLEET

This section describes how to pair your LINK 105 with the LINK 5xx/4xx installed in your vehicle
using WEBFLEET. You can also
instead.
Note: Make sure your vehicle is properly fitted with a LINK 5xx/4xx according to the
ments for the installation.
1. Log in to WEBFLEET here telematics.tomtom.com/login.
2. Click Vehicles.
3. Select your vehicle from the list.
4. In the details panel on the right, click Contract/Device.
vehicle.
configure a Bluetooth connection using the Activation Tool
7
reset the device
require-