Table of Contents
Advertisement
Before the installation
Notice for maintenance work
If you need the OBD-II connector in your vehicle, for example for maintenance, remove your LINK
105 from the connector and reconnect it afterwards.
Important: To remove the LINK 105 from the OBD-II connector, pull on the handle of the LINK 105
and not the device itself as this may cause damage.
Components
The following figure shows the different parts of the LINK 105.
1. Handle
2. Reset button
3. Bluetooth LED (Blue)
4. Power LED (Green)
5. Body
6. Bluetooth address
7. OBD-II plug
Requirements
Before installing your LINK 105 make sure you fulfil the following requirements:
Your vehicle is fitted with a LINK 5xx/4xx with the firmware version 5.0 or higher.
The LINK 5xx/4xx must be activated in WEBFLEET.
Your vehicle has an OBD-II connector. If the OBD-II connector of your vehicle does not provide
enough space to insert the LINK 105, you can use the OBD-II extension cable from TomTom
Telematics.
To use the Activation Tool for your LINK 5xx/4xx, you need a laptop with the Activation Tool
installed, the Mini USB cable and the activation code, which you can find in your WEBFLEET
contract confirmation.
5
Advertisement
Table of Contents
