Examples; Enabling Nls Functionality - Cisco cBR-8 Configuration And Troubleshooting Manual

Control Point Discovery
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2 configure terminal
Example:
Router# configure terminal
Step 3 cpd cr-id
Example:
Router (config)# cpd cr-id 100
Step 4 end
Example:
Router# end

Examples

The following example shows the cpd cr-id command configured with a cr-id number of 100 on a router.
Router (config)# cpd cr-id 100

Enabling NLS Functionality

To enable the NLS functionality, use the nls command in global configuration mode. It is recommended that
NLS message authentication be enabled at all times.
DETAILED STEPS
Command or Action
Step 1
enable
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Configures a control relationship identifier (CR ID) for CMTS.
Exits global configuration mode and enters privileged EXEC
mode.
Purpose
Enables privileged EXEC mode.
Enabling NLS Functionality
for Cisco IOS XE Fuji 16.8.x
103