Table of Contents
Advertisement
Panel Descriptions
Input section
fig.front01.eps
1
1
3
3
4
4
1.
[TUNER] button
If you press this while the editor is running, the Tuner in
the VS-20 Editor will appear.
Here you can tune your instrument.
2.
SENS knob/PEAK indicator
This adjusts the sensitivity of the signal that's being
input to the MIC 1, MIC 2, LINE, and GUITAR/BASS jacks.
If an excessive input signal is detected, the PEAK
indicator will light.
For the best possible recording quality, input the signal and
adjust the [SENS] knob until it is as high as you can get it
without causing the PEAK indicator to light.
3.
[MIC 1] button
This button enables the signal input from MIC 1 (built-
in stereo mics).
4.
[MIC 2] button
This button enables the signal input from MIC 2 jack.
5.
[LINE] button
This button enables the signal input from LINE jacks.
6.
[GUITAR/BASS] button
This button enables the signal input from GUITAR/BASS
jack.
By pressing [MIC 2] and [GUITAR/BASS]
simultaneously, you can make input settings for
simul-recording. For more about simultaneous
recording, refer to p. 28.
20
Transport section
fig.front01.eps
2
2
5
5
6
6
Here you can control the V-STUDIO's playback and
recording.
1
2
3
1.
[
] button
Press this button to move the Now Time to the
beginning of the project.
2.
[
] button
Press this button to rewind the Now Time.
3.
[
] button
Press this button to stop playback.
4.
[
] button
Press this button to start playback.
If you press this button during playback, the playback
pauses. Press again, to resume playback.
5.
[
] button
Press this button to fast-forward the current time.
6.
[
] button
Press this button to start recording on tracks that are
selected for recording (record enabled).
If you press this button during playback, you can start
recording tracks that are record-enabled without
stopping playback.
4
5
6
Advertisement
Table of Contents
