Using The Rpc-1'S Mixer To Return The Input Sound - Roland SI-24 Owner's Manual

Using the RPC-1's mixer to return the input sound

This allows latency-free monitoring (i.e., monitoring with no delay). Also, you will
be able to monitor the input sound at any time, unless you change the settings.
1. Open the RPC-1 control panel.
2. Click the "Monitor Mixer" tab.
3. Make settings as shown in the illustration.
fig.M01
4. Use the slide bar (
"R-Bus In 1/2"–"R-Bus In 7/8."
5. Make settings as shown in the illustration.
fig.M02
Set all of the "R-Bus In 1/2"–"R-Bus In 7/8"
faders to 0 dB (highest).
Adjust the pan as appropriate.
Uncheck all "Mute" boxes.
fig.M03
6. Click the "Patchbay/Router" tab.
fig.M04
7. As shown in the illustration, set the "R-Bus Out 1/2"
source to "Monitor Mixer."
Set both "WavOut 1/2" faders to 0 dB (highest).
Set pan to left and right.
Uncheck both "Mute" boxes.
) to scroll the screen to the left, to display
Monitoring the SI-24's inputs
For details on operation, refer
to the column "How to open
the RPC-1 control panel"
(p. 20).
21