Kodak 9000 User Manual page 7

WARNINGS:
•
You are responsible for the operation and maintenance of this unit. Only legally
qualified persons can operate this unit. DO NOT open the cover of the unit.When
necessary, have a trained authorized service technician carry out inspection and
maintenance operations.
•
Install this Unit in an x-ray room that complies with current installation
standards. From this location, you must be able to maintain visual or audio
communication with the patient and be able to access the Acquisition interface
module during exposure. This Unit must be permanently connected to the
ground with a fixed power supply cable.
•
DO NOT place the PC and the peripheral equipment connected to it in the
immediate vicinity of the patient in the Unit. Leave at least 1.5 m distance
between the patient and the Unit. The PC and the peripheral equipment must
conform to the IEC60950 standard.
•
See your computer installation guide for details of the data processing system,
PC and screen. Leave a sufficient amount of clear space around the CPU to
ensure that it is properly ventilated.
•
To obtain maximum image quality and visual comfort, position the screen to
avoid direct light reflections from internal or external lighting.
•
DO NOT operate the Unit if there is the threat of an earthquake. Following an
earthquake, ensure that the Unit is operating satisfactorily before using it again.
Failure to observe this precaution may expose patients to hazards.
•
X-ray equipment is hazardous to patients and the operator if you do not observe
the exposure safety factors and operating instructions.
•
DO NOT place objects within the field of operation of the Unit.
•
The patient should wear a protective lead-lined shoulder apron, unless other
Radiation Protection Protocols apply locally.
•
Disinfect any parts of the Unit that come into contact with the patient and the
operator after each patient has been exposed to x-rays.
•
While adjusting the height of the Unit, ensure that the patient is kept clear of the
mechanism.
•
When the Unit is not in use, ensure that the ON/OFF switch is set to OFF (O).
•
If the Unit develops a fault, switch it to off (O), display an "Unserviceable" notice
and contact a service technician.
•
To dispose of the Unit or its components, contact a service technician.
•
Ask the patient to refrain from moving during the entire period of exposure.
•
Ask the patient to remain still until the Unit arm has stopped moving and the
RESET movement has completed.
•
DO NOT use this Unit in conjunction with oxygen-rich environments. This Unit
is not intended for use with flammable anesthetics or flammable agents.
KODAK 9000 3D Extraoral Imaging System_User Guide (SM710)_Ed 01
Warning and Safety Instructions
1–3