Motion Detect; Video Blind - Videocon WallCam Quick Setup Manual

4.4.1 Motion Detect

When system detects the motion signal that reaches the set sensitivity, the motion detect
function and the linkage function will be turned on.
Note: Click on the advanced button to go back to the previous page to view display
surveillance screen and recording setup.
Picture 4.21 motion detect
Channel: Choose the set motion detect channel.
Enable: means that the motion detect function is on.
Period: Trigger the motion detect signal in the set time section. Each day is divided
into four time sections. means the set is valid.
Picture 4.22Make/cancel defence time quantum
Interval: Only one alarm signal is turned on even there are several motion detection
signals in the set interval.
Alarm output: When sensor senses the motion, the alarm will be triggered to the NVR.
Delay: Delay a few moments and stop when the alarm state is turned off. The range is
10~300 seconds.
Record channel: Choose the recording channel (Supports multiple options). Trigger the
video signal when the alarm is turned on.
Note: Set in the "main menu" "record"
And set "desktop shortcut menu" "record mode" to be configured, motion detect linkage
recording can work
Tour: choose the recording channel (Supports multiple options), which will preview the
single screen in case of alarm alert.
"record plan" and perform the linkage recording.
21

4.4.2 Video Blind

When the video image is influenced by outer environment or lighting and reaches the set
sensitive parameter, the video blind function and the linkage function is turned on.
Note: You would need to open the IPC video blind function first and make sure that the IPC
is well connected with NVR before opening the video blind function.
Picture 4.24 Video Blind
Set method: refer to Chapter 4.4.1. Motion Detect
4.4.3 Video Loss
When the equipment cannot obtain the channel video signal, the video loss alarm and
the linkage function is turned on.
Picture 4.25 video loss
22