Connecting Multiple Pcs To An Ethernet Lan - GE Security MCE-Coax User Manual

Connecting Multiple PCs to an Ethernet LAN

The following procedures will help you setup the MCE-Coax to an Ethernet
LAN.
1. Set the MCE-Coax to be in CO or CPE mode with the DIP switch at the
rear panel.
2. Power on the MCE-Coax by connecting a power source (not supplied
with unit).
3. Power LED will illuminate.
4. Connect a VDSL line/coaxial cable from another VDSL device to the VDSL
BNC port of the MCE-Coax.
5. LNK LED will illuminate.
6. Connect the Ethernet port to an Ethernet Switch (or Broadband Router)
via regular Cat. 5/5e cable.
Figure 6: Connecting Multiple PCs to an Ethernet LAN
NOTE: Please refer to your Ethernet device's User Manual for the device's set
up information.
MCE-Coax Converter User Manual
Chapter 3: Installation
15