Chapter 3: Installation
Connecting MCE-Coax
Connecting to a Standalone IP device
The following procedures will help you setup the MCE-Coax to a standalone
PC.
1.
Set the MCE-Coax to be in CO or CPE mode with the DIP switch at the
rear panel.
2.
Power on the MCE-Coax by connecting a power source (not supplied
with unit).
3.
Power LED will illuminate.
4.
Connect coaxial cable from another VDSL device to VDSL BNC port of
the MCE-Coax.
5.
LNK LED will from blinking to illuminate.
6.
Connect the Ethernet port to another Ethernet device via regular Cat.
5/5e UTP cable.
Figure 5: Connecting Standalone IP device
14
MCE-Coax Converter User Manual