Power Information - GE Security MCE-Coax User Manual

Chapter 2: Hardware Overview
a long reach data receiver. The CPE can be connected to the PC, IP
Camera or Wireless Access Point and various network devices.
Fast and Interleave mode: (For CO Mode only)
• Fast mode guarantees a minimum end to end latency of less than 1 ms.
• Interleaved mode provides impulse noises protection for any impulse
noise with a duration less than 250 us. Interleaved mode has a
maximum end to end latency of 10m sec.
Rate Limit: (For CO Mode only)
User has the ability to select fixed data rate. When a Rate Limit is selected,
the system will lock the data rate at 50Mbps/20Mbps whenever the
calculated SNR margin is higher than 9 dB. This gives the best system
stability.
Target SNR (Signal Noise Ratio) Margin: (For CO Mode only)
When a fixed SNR margin is selected, the system will maintain the SNR
margin at 9 dB across all usable loop length.

Power Information

Remove power from the converter before making any transmission mode
adjustments.
MCE-Coax requires 5V DC power input.
NOTE: The device is a power-required device, that means, it will not work
untill it is powered. If your networks are active all the time, please consider
using UPS (Uninterrupted Power Supply) for your device. It will prevent
network data loss or network downtime.
In some areas, installing a surge suppression device may also help to protect
your converter from being damaged by unregulated surge or current to the
converter or the power adapter.
10 MCE-Coax Converter User Manual