Section 1: Heater Safety; Manpower Requirements; Safety Labels And Their Placement - Roberts Gorden Combat UHA[X][S] 100 Installation & Operation Manual

SECTION 1: HEATER SAFETY

Your Safety is Important to Us!
This symbol is used throughout
the manual to notify you of
possible fire, electrical or burn
hazards. Please pay special
attention when reading and
following the warnings in these
sections.
Installation, service and annual
inspection of heater must be done by a contractor
qualified in the installation and service of gas-fired
heating equipment.
Read this manual carefully before installation,
operation or service of this equipment.
Not all heaters are approved for residential
installation. Check the heater's silver rating plate for
residential approval status. Heaters that do not have
residential approval must not be installed in
residential spaces. These instructions, the layout
drawing, local codes and ordinances and applicable
standards that apply to gas piping, electrical wiring,
venting, etc. must be thoroughly understood before
proceeding with the installation.
Protective gear is to be worn during installation,
operation and service. Thin sheet metal parts,
including the various venting components, have
sharp edges. To prevent injury, the use of work
gloves is recommended.
Before installation, check that the local distribution
conditions, nature of gas and pressure and
adjustment of the appliance are compatible.

1.1 Manpower Requirements

To prevent personal injury and damage to the
heater, two persons will be required for installation.

1.2 Safety Labels and Their Placement

Product safety signs or labels should be replaced by
product user when they are no longer legible.
Please contact Roberts Gordon LLC or your
®
ROBERTS GORDON
obtain replacement signs or labels. See Page 2,
Figure 1 through Page 4, Figure 3.
independent distributor to
SECTION 1: H S
EATER AFETY
1