CTHN-S
I
, O
ERIES
NSTALLATION
PERATION AND
SECTION 7: GENERAL SUSPENSION DETAILS
To ensure your safety and comply with the terms of
the warranty, all units must be installed in
accordance with these instructions.
FIGURE 12: Critical Hanger Placement
Description
Part Number
S-Hook
91907302
Tube/Reflector Hanger
03090100
10
S
M
ERVICE
ANUAL
10' (3 m) - 50' (15 m)
51' (15.5 m) - 60' (18 m)
61' (18.6 m) - 80' (24 m)
The gas or the electrical supply lines must not be
used to support the heater.
Do not locate the gas or electric supply lines directly
over the path of the flue products from the heater.
The heater must be installed in a location that is
readily accessible for servicing.
The heaters must be installed in accordance with
clearances to combustibles as indicated on the rating
plate and in this instruction manual.
The minimum and maximum gas inlet pressures
must be maintained as indicated on the rating
plate.Typical installation configurations are shown in
Figure 12.
Run Length
Typical Expansion
±1" (3 cm)
±2" (5 cm)
±3" (8 cm)
Minimum "X" Length
12" (30 cm)
18" (46 cm)
24" (61 cm)