Table of Contents
Advertisement
5-3 Communication Setting
You can set communication conditions by 2 methods, using the communication set switches on the
front of main unit and using the setting software (Configurator WD).
5-3-1 Set by the communication set switches on the unit
Use ④Communication set switch 1 and ⑤Communication set switch 2 to set communication setting.
④Communication set switch 1
MODE
Item
1
Transmission
2
speed
3
Setting
4
method
<Table>
MODE 1
MODE 2
OFF
OFF
ON
OFF
OFF
ON
ON
ON
OFF
OFF
ON
OFF
OFF
ON
ON
ON
Note 1）Only when MODE 4 of ④switch 1 is set to ON(Hardware),
④ and ⑤ switches' setting is available.
2）When MODE 4 of ④switch 1 is set to OFF (Software),
④ and ⑤ switches' setting is not available.
3）Data length is fixed with 8 bit.
4）Setting conditions are read when power turns on. You should set them before power turns on.
If you change the settings while power turns on, some malfunctions might be occurred.
5）When setting by hardware (communication set switches), RS232C and RS485 communication
settings are set as same. (If individual setting for RS232C and RS485 is required, use the
setting software.)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
OFF
ON
Below table
Software
Hardware
note1)
MODE 3
Transmission speed
OFF
115200bps
OFF
2400bps
OFF
4800bps
OFF
9600bps
ON
19200bps
ON
38400bps
ON
57600bps
ON
115200bps
⑤Communication set switch 2
No.
Item
1
Parity
Not available
2
Parity
Even number
3
Stop bit
4
vacant
12
OFF
ON
Available
Odd number
2
1
Advertisement
Table of Contents
