Philips DVDR3570H/05 Service Manual page 8

1.4. Procedure for checking Development Version Info Screen
Notes: For detail software information such as Slash Version, Drive Software Version, etc of the set, the
development version info screen should be accessed.
1) Power up the set
2) Press <OPTIONS> button on the Remote control and go to <Settings> option
3) Then go to <Setup> and choose <Version Info> by pressing OK.
4) When the user version info screen is appeared, press the blue key on the remote control.
5) The TV connected to the set will display the Development Version Info Screen as shown below:
Version Info
(c)PHILIPS 2006 Version Information:
DI L+06_7/751731 SV 11602
BE 52.07.02.15 ASP 1,18,1,10
C1_7 20070224_1659 pro lecoplusleadV2 <void>
EPG: DPMS:P_DPM
Digital Board Info: (DI: Digital Board, L+06_7: Digital Board name, 75: Hardware ID for EU Non EPG, 1731: SW
BUILD ID for recorder application in the example)
Slash Version (xxxxx = version): SV xxxxx (11602 for /51 in the example above)
Drive SW Version (yy.yy = model, xx.xx = version): BE yy.yy.xx.xx (Model 52.07, Version 02.15 in the example)
ASP Software and VFD Driver Version Number: (1,18: ASP software version number, 1,10: version number of
VFD Driver
Detailed Build Information: (C1_7: Branch Information, 2007: year, 02: month, 24: date, 16: Hour, 59: minute in
the above example)
EPG: DPMS:P_DPM (internal to the recorder application.)
1.5. Procedure for Formatting a HDD drive
In case of failure the HDD is replaced by a new unformatted HDD. To prepare the new HDD for use, it must be
formatted. Follow the procedure below to format HDD.
1) Press and Hold the <Previous> + <Stop> key combination while powering on the mains.
2) The set will start to display "FMT KEY", and then it will show "FMT HDD" while formatting HDD.
3) If the formatting is completed successfully, the set will display "FMT DONE". If the formatting is failed, it
will show "FMT FAIL".
Notes: Do not power off the set immediately when the "FMT DONE" is seen. Wait until the time or - - : - - is
displayed before powering off the set.
1.6. Procedure to Virginize the set
Notes: All the user information will be lost after virginizing the set. Follow the procedure below to virginize the
set.
1) Press and hold down the Standby key on the front while connecting to the power outlet.
2) Release the keys when the scrolling messages appear on VFD.
3) Press Standby key again and follow the instructions when the set wakes up.