To Check Previously Installed Unit - Worcester DT20RF Instruction Manual

8_716_115_495a 9/2/09
DIGISTAT
INSTALLATION
DT20RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 495a (02.2009)
11:49 Page 27
To check signal strength on previously
installed and paired units :
1. Press the 'set' button 4 times.
2. Press 'OK' once.
3. Press the 'set' button 5 times. The display will
show 'SSI and OFF'.
4. Press the '+' button so that the display shows
'SSI, Antenna and ON'.
5. Press the 'set' button so the display shows 'SSI
and Antenna'.
6. After a few seconds the display will show '---'.
7. Remove the batteries from the transmitter and wait
until the display has faded away.
8. Press and hold the SET button on the transmitter
while re-inserting the batteries and keep the
button depressed until the display shows 'rF' .
DIGISTAT / DT20RF RECEIVER
TO CHECK PREVIOUSLY
INSTALLED UNIT
OPERATING & INSTALLATION
INSTRUCTIONS
25