To Cancel Signal Strength Mode - Worcester DT20RF Instruction Manual

8_716_115_495a 9/2/09
DIGISTAT / DT20RF RECEIVER
TO CANCEL SIGNAL
STRENGTH MODE
OPERATING & INSTALLATION
24
INSTRUCTIONS
11:49 Page 26

To cancel signal strength mode:

1. Remove the batteries from the transmitter to
cancel the constant transmission.
2. After a few seconds the receiver display will
show '---' .
3. Press 'OK' on the receiver display and the display
will return to the time with the 'CH and Antenna'
flashing.
4. Re-insert the batteries into the transmitter and the
RF link will be re-established.
DT20RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 495a (02.2009)
DIGISTAT
INSTALLATION