Mounting The Digistat - Worcester DT20RF Instruction Manual

8_716_115_495a 9/2/09
DIGISTAT
INSTALLATION
DT20RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 495a (02.2009)
11:49 Page 25
Positioning the Digistat RF room thermostat
The Digistat is a radio frequency device which is very
flexible for positioning as there is no need for hard
wiring to the appliance. The device should be mount-
ed in a open area, no closer than 30cm from metal
objects, including wall boxes.
Mount the Digistat on a wall which is not subject to
direct sunlight or draughts, preferably on an inside
wall, 1.5 metres above the floor. The Digistat must
also not be directly influenced by radiators or other
appliances giving off heat.
Mounting the Digistat RF room thermostat
1. Loosen the single screw from the bottom of the
transmitter using a small flat bladed screwdriver.
2. Carefully insert the screwdriver into the slot
located at the back of the digistat near the top
and very gently lever upwards a fraction to release
the tab securing the front of the transmitter to the
back cover.
The the back cover can now be secured to the
wall.
3. Replace the front by locating in position and
pushing fully onto the back cover until the tab
engages at the top of the transmitter.
4. Retighten the screw at the bottom of the unit to
fully secure the front to the back cover.
DIGISTAT / DT20RF RECEIVER

MOUNTING THE DIGISTAT

OPERATING & INSTALLATION
INSTRUCTIONS
23