Table of Contents
Advertisement
❋
VARI
LITE - S
550 W
ERIES
Control Channel Functions
The following control actions must be accomplished with zero time transition or with timing disabled.
Discrete values must be used and not manual controls such as faders or encoders.
*For Arc and CD Models only.
To use control channel functions:
Step 1. Select an action to be sent.
Step 2. Set control channel value for desired action (for example, 84 for reset). Hold value for 3
seconds.
Note: A numerical keypad is required for sending values. An encoder or fader does not allow for a
"snap" value change, which is required to affect the control functions.
Step 3. Set control channel value to zero. (This must occur without any scaling values. Action will
be voided if other values are detected between action value and zero.)
36
L
U
'
ASH
UMINAIRE
SER
Table 3-5: Timing Channels Map (Continued)
% Value
98
99
100
Table 3-6: Control Channel Functions
Control
Channel
% Value
Function
Soft Reset
Lamp On*
99 - 100
Lamp Off*
Note: Remaining DMX values are for future use.
16 No vemb er 2010
M
S
ANUAL
DMX
250
251
252
253
254
255
Control Channel Value
DMX Value
33
81 - 87
249 - 255
66
165 - 171
= Seconds
300
310
310
310
310
Follows Cue Data
After
3 Secs
0
0
0
02 .9 683.00 01 0
Advertisement
Table of Contents
