Table of Contents
Advertisement
Fig.16
GRATE REMOVAL & CLEANING
Over time fuel deposits, clinker & ash can lodge
between the grate and grate support which can
cause difficulties when moving the grate during de-
ashing. To help reduce this occurrence, it is recom-
mended that the grate is cleaned on a monthly basis
when undertaking the general cleaning of the flue
pathways using the following procedure:
1. The grate is removed by removing the ashpan
and then lifting the grate out of the grate insert
from underneath the grate (See fig. 17)
Fig.17
PERIODIC MAINTENANCE
CHIMNEY CLEANING
The chimney should be cleaned twice annually or if
the stove is not used for a prolonged period during
the summer period, it should be cleaned prior to
commencement of usage. The chimney can be
cleaned through the stove depending on the flue
configuration and the flue liner should be cleaned in
accordance with manufacturer's instructions. Always
use a brush with plastic bristles that is the correct
size to reach all areas of the flue.
GLASS CLEANING
The stove glass will self-clean when there is suffi-
cient heat generated by the burning fuel i.e. when
the unit is operated at the maximum air settings. If a
build-up of creosote occurs on the glass it may be
due to low draft conditions, poor quality fuel or oper-
ating the stove at the minimum air settings for long
periods of time. The glass should be cleaned when
cool and cleaned with a non-abrasive cloth using
warm soapy water. For stubborn deposits, a grade 0
steel wool can be used whilst tak¡ng care not to
scratch the glass with any coal/ash deposits.
CLEANING THE OUTER CASING
Cleaning should be done when the stove is cold by
removing any dust or dirt using a dry cloth. Do not
use any water on the matt
black/senotherm finish as this will cause it to rust.
18
Hide quick links:
Advertisement
Table of Contents
