Horizontal Spool Pin; Bobbin And Thread Tension Adjustments - Janome QUILT MAKER PRO Instruction Manual

Optional Horizontal Spool Pin
Figure 16
Bobbin and Thread Tension
Adjustments
Inserting the Bobbin
Note: Turn off the power switch while inserting the
bobbin case or anytime your hands are near the needle
area.
1. Place the bobbin in the bobbin case so that the
thread pulls off clockwise when viewing the open side
(Figure 17).
Figure 17
2. Slide the thread through the slot (Figure 18) and
under the tension spring leaving 5 to 6 inches of
thread hanging loose (Figure 19).
janome.com
1. An optional horizontal spool pin is available for
metallic and specialty threads wound on a spool (not
a cone).
2. The horizontal spool pin mounts on the laser stylus
guide post on the top of the machine
(see Figure 16).
3. When using threads on the Horizontal Spool Holder,
skip thread guide A. Thread the top hole only of the
three-hole thread guide B, back to front.
4. Continue threading the machine as described in steps
3 through 7 on page 16.
Figure 18
TENSION
SPRING
Figure 19
Page 17