Table of Contents
Advertisement
block inside the unit control box. See
Figure
60. Refer to the customer
connection diagram that is shipped
with the unit for specific termination
points.
Provide proper grounding for the unit
in accordance with the local and
national codes.
Control Power
Transformer
The 24-volt control power
transformers are to be used only with
the accessories called out in this
manual. Transformers rated greater
than 50 VA are equipped with
internal circuit breakers. If a circuit
breaker trips, turn OFF all power to
the unit before attempting to reset it.
WARNING
Hazardous Voltage!
Disconnect all electric power,
including remote disconnects before
servicing. Follow proper lockout/
tagout procedures to ensure the
power can not be inadvertently
energized. Failure to disconnect
power before servicing could result
in death or serious injury.
The transformer is located in the
control panel.
Figure 60.
Power wiring example
WSHP-SVX01E-EN
Installation
Thermostat Location
Location of the thermostat or zone
sensor is an important element of
effective room control.
Areas where the thermostat or zone
sensor should not be located include:
Behind doors or corners; Near hot or
cold air ducts; Near radiant heat (heat
emitted from appliances or the sun);
Near concealed pipes or chimneys;
On outside walls or other non
conditioned surfaces; In air-flows
from adjacent zones or other units.
See
Figure 61
for thermostat/sensor
location.
YES
NO O
Figure 61.
Thermostat/sensor location
NO
NO
55
Hide quick links:
Advertisement
Table of Contents
