B&B Electronics 232MSS2 User Manual page 10

ASCII character STX (decimal 2). The third character should be the
ASCII upper case letters "A", "B", "C" or "D" (decimal 65, 66, 67, or
68 respectively) to select those ports. To turn off the selected port
the third character should be the ASCII EOT character (decimal 4).
For instance, to turn on port B you would send:
If you were writing a program in BASIC to control the Mini Smart
Switch you would form a string like this:
SWB$ = CHR$(27) + CHR$(2) + "B"
You could then send SWB$ to select port B. Similar strings
could be used for turning on the other ports. To turn off the ports the
string might look like this:
TOFF$ = CHR$(27) + CHR$(2) + CHR$(4)
When you are done with a port you can either select a new one
directly or turn off the selected port and then turn on the next one.
We recommend that you turn off the selected port before selecting
the next one. The turn off command consists of three characters that
are nonprinting (ESC STX EOT). If port A is selected and you send
the command to select port B, all three characters (ESC STX B) will
pass through the A port since it is still selected and the letter B will
show up on your port A device. For information on preventing
command codes from being received by slave devices, refer to the
Enhance Mode section.
NOTE: There is no delay through the Mini Smart Switch and
the data is not buffered.
6
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445
ESC STX B
Documentation Number 232MSS2-0108 Manual