Verifying The Configuration - HP FlexFabric 5700 Series Configuration Manual

[SwitchB-vsan1] quit
# Create interface VFC 3.
[SwitchB] interface vfc 3
# Configure the mode of VFC 3 as F.
[SwitchB-Vfc3] fc mode f
# Bind VFC 3 to interface Ten-GigabitEthernet 1/0/3.
[SwitchB-Vfc3] bind interface ten-gigabitethernet 1/0/3
# Assign VFC 3 to VSAN 1 as a trunk port.
[SwitchB-Vfc3] port trunk vsan 1
[SwitchB-Vfc3] quit
# Configure Ten-GigabitEthernet 1/0/3 as a trunk port, and assign the port to VLAN 10.
[SwitchB] interface ten-gigabitethernet 1/0/3
[SwitchB-Ten-GigabitEthernet1/0/3] port link-type trunk
[SwitchB-Ten-GigabitEthernet1/0/3] port trunk permit vlan 10
[SwitchB-Ten-GigabitEthernet1/0/3] quit
# Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 1.
[SwitchB] vlan 10
[SwitchB-vlan10] fcoe enable vsan 1
[SwitchB-vlan10] quit

Verifying the configuration

# Display the nodes on downlink interfaces and their mapped uplink interfaces.
[SwitchA] display npv login
Server
Interface VSAN FCID
Vfc1
Vfc2
# Display the status of Switch A.
[SwitchA] display npv status
External Interfaces:
Interface: Vfc3
VSAN
1
Number of External Interfaces: 1
Server Interfaces:
Interface : Vfc1
VSAN
1
Interface : Vfc2
VSAN
1
Node WWN
1 0x010001 20:00:00:00:c8:00:e4:30 21:00:00:00:c8:60:e4:9a Vfc3
1 0x010002 20:00:00:00:c9:00:e4:30 21:00:00:00:c9:60:e4:9a Vfc3
VSAN tagging mode: Tagging
State FCID
Up 0x010000
VSAN tagging mode: Tagging
State
Up
VSAN tagging mode: Tagging
State
Up
Port WWN
100
External
Interface