Operation; Settings Table - Greenlee DM-830A Instruction Manual

Find Quality Products Online at:

Operation

Electric shock hazard:
Contact with live circuits could result in severe injury or death.
1. Refer to the Settings Table. Set the selector to the proper setting, press SELECT (when instructed to
do so), and connect the test leads to the meter.
2. Refer to "Typical Measurements" for specific measurement instructions.
3. Test the unit on a known functioning circuit or component.
• If the unit does not function as expected on a known functioning circuit, replace the battery and/
or fuses.
• If the unit still does not function as expected, call Greenlee for technical assistance
at 800-435-0786.
4. Take the reading from the circuit or component to be tested.

Settings Table

The meter stores the last used function of each selector position in its nonvolatile memory. If this is not
the correct function when you turn the selector, press SELECT until the desired icon appears.
The dual display options are shown along with the icons. In the table, "~V
appear in the primary display, and "Hz" appears in the secondary display. This combination shows the
AC voltage measurement in the primary display and frequency in the secondary display.
To measure this Set the selector to
characteristic ... this symbol ...
All Models
Voltage—AC
(1000 V max)
Voltage—DC
(1000 V max)
Voltage—DC
(600 mV max)
Voltage—AC
(600 mV max)
This table continues on the next page.
14
GlobalTestSupply
www.
Hz
" indicates that "~" and "V"
Press SELECT until Connect Connect the
these icons appear on the red
the display ... lead to ...
Hz ~V
V or Hz
ΩV
~V
V or V
ΩV
mV or mV ~mV
ΩV
mV Hz or Hz ~mV
ΩV
.com
black lead
to ...
COM
COM
COM
COM
sales@GlobalTestSupply.com