Buttonhole With Gimp; Buttonhole Foot With Slide - Bernina Industrial 950 Instruction Manual

Buttonholes with gimp
Use gimp for stretchy
fabrics so that the button-
hole does not distort.
Practical sewing
Placing the cord
Place the cord over the
centre stem of the foot.
'" Buttonhole foot with slide*
" Presser foot: 3B
Thread: Machine or
embroidery thread
Needle: 80 - 70
Stitch selector: 0
Stitch converter: 0
Stitch length almost 0
Feed-dog: raised (sewing)
Sew buttonholes as
described on page 14.
Marking the length
After sewing the first
bead, 'adjust the red slide
on the side of the foot to
the length of the bead.
All further buttonholes
will now be sewn to this
length.
Silde foot with gimp cord
Guide the cord under the
foot and hook it over the
prong on the back of the
foot.
Bring the cord under the
foot, insert both ends into
the front retaining slots
and cut.
The cord is automatically
oversewn when you sew
the buttonhole.
Sewing the buttonhole
Take both ends under the
foot to the rear.
Lower the foot and check
whether the cord slides
easily. Sew the buttonhole
as described above, hol-
ding the cord lightly.
*
BERNINA special accessory
15
Knotting the cord-ends
Pull the loop into the but-
tonhole and take the ends
of the cord th roug h to the
wrong side and knot.