Release Printer - TEC tecjet 6090uv-xp600 User Manual

Chapter 3. Release Printer
◇ Please check if the four angel of the flatbed is water level as the flatbed may out of position during rough
delivery, so we check first,
◇ Place the machine after removing the package. Insert the power cord as indicated in Fig.1. Please pay
attention to voltage in your own area. Make sure the ground wire is well connected to avoid the leakage of
electricity.
Please ask TEC support team to be sure your printer is 110V or 220V, it will damage printer if load wrong voltage!
◇
Please DO NOT make USB cable connected at first.
◇
Press Power Button ， and then press Auto. Till platform is backward to stop, press Printer Ready Switch
to start printer.
◇
Self-Inspection will be executed when the machine starts, which will take about 2 minutes. Ready light is
flashing at this time. DO NOT execute any actions at this moment. On-line light will be normally on after
the start. Test machine' condition by pressing Enter, Out, Up and Down.
【！】 Warning
p
Press General Power Button before turning on printer, then press Ready button about 3 seconds later to
start main engine of printer.
p
First press READY, and then press GENERAL Power Button to turn the power and printer off.
p
DO NOT SEND MORE THAN ONE PRINTING JOB TO RPINTER WHEN THE FIRST JOB IS NOT
FINISHED!
p
DO NOT use two different USB cable at the same time.
（ Fig.1 ）
TJ UV Printer User Manual
17