Clearing Sprocket Cover Of Debris; Extension Cords - Remington M12510US, M15012US, M15014US, M15014AS, M30016US, M30016AS, M30016AW, M30016UW, M35016US, M35016AW Owner's Manual

OPERATING CHAIN SAW
Continued
CLEARING SPROCKET COVER OF
DEBRIS
While operating the chain saw, wood chips, small
twigs, and other debris can occasionally build up
inside the sprocket cover. To properly maintain the
saw and keep it in good working order, periodic re-
moval of this debris may be required. To properly
clear debris from the sprocket cover:
1. Unplug chain saw.
2. Loosen and remove guide bar nut (see Figure
10).
3. Turn chain tensioning screw counterclockwise
to loosen chain until sprocket cover is easily re-
moved.
4. After sprocket cover is removed, clear all chips,
twigs, and debris.
WARNING: Use caution when clear-
ing debris that is around chain. Cutting
edges on chain are sharp. Use protec-
tive gloves when working around or han-
dling chain.
5. Once debris has been removed, follow steps 7
through 11 on pages 7 and 8 in the Assembly
section to re-assemble the sprocket cover to the
chain saw.
Sprocket Cover
Figure 10 - Removing and Clearing Sprocket
Cover of Debris
www.desatech.com
Wood Chips, Twigs,
and Debris
Guide Bar Nut
10

EXTENSION CORDS

Use proper extension cords with this saw. Use only
extension cords marked for outdoor use. The cord
must be marked with suffix W or W-A following the
cord type designation. Example: SJTW-A or SJTW.
Use proper sized cord with this saw. Cord must be heavy
enough to carry current needed. An undersized cord will
cause voltage drop at saw. Saw will lose power and
overheat. Follow cord size requirements listed below.
Cord Length
25 feet
50 feet
100 feet
150 feet
Models M12510US, M15012US, M15014US,
M15014AS
Cord Length
25 feet
50 feet
100 feet
150 feet
Models M30016US, M30016AS, M30016AW,
M35016UW, M35016AW
Keep cord away from cutting area. Make sure cord
does not catch on branches or logs during cutting.
Inspect cords often. Replace damaged cords.
This chain saw is designed with an extension cord hitch
that prevents the extension cord from being pulled loose
during use. To use, form a loop with the end of the
extension cord, insert loop into slot in rear of handle,
and place loop over cord hitch (see Figure 11). Gently
pull loop against cord hitch until slack is removed. Plug
extension cord into chain saw cord.
Cord Hitch
Extension Cord
Figure 11 - Looping Extension Cord over Cord
Hitch
AWG Cord Size
16 AWG
16 AWG
16 AWG
14 AWG
AWG Cord Size
16 AWG
16 AWG
14 AWG
12 AWG
Power Cord
113005