Operating The Blower/Vac - Remington BV12200A, BV1220DAT Owner's Manual

8
| chapter 4: blower/vac operation
Operating the
Blower/Vac
The on/off toggle switch has three settings;
off, low, and high. The middle switch po-
sition, marked "O", is off. The rear switch
position, marked "I", is low. The forward
switch position, marked "II", is high. See
Figure 4-4.
Blower Operation
WARNING: The blower can
throw debris, causing injury to
those nearby.
• Do not blow nails, bolts, rocks,
or other hard objects.
• Do not operate blower near
bystanders or pets.
• Be careful when blowing de-
bris from stairs, corners, or
other tight areas. Objects can be
blown back toward operator.
• Wear approved eye protection,
long pants, and shoes while
operating this blower/vac.
Properly assemble the blower/vac for
blower operation (see page 4, Assembling
Blower). Follow the steps below to operate
the blower.
1. Hold blower/vac using the handle on
housing (see Figure 4-5).
2. When ready to start the blower, toggle
the on/off switch to either the low "I"
or high "II" setting (see Figure 4-6).
3. To stop the blower, toggle the on/off
switch to the off "O" setting.
Figure 4-4: On/Off switch positions
Figure 4-5: Holding blower/vac for blower operation
Figure 4-6: On/Off Switch to LOW position
Figure 4-7: Operating blower
120133