Deskset Installation; Important Information - VTech VSP715 Quick Reference Manual

MODEL: VSP715
Back Panel Features
Deskset
stand slots
Ethernet port
PC port
Corded
headset jack

Deskset Installation

This section assumes that your network infrastructure
is established and that your IP PBX phone service
has been ordered and configured for your location.
For more information about installation options
and phone setup, see the VSP715 Deskset User
Guide and the VSP715 Deskset Administrator and
Provisioning Manual, available at
businessphones.vtech.com.
You can power the phone using a compatible VTech
AC power adapter or using Power over Ethernet
(PoE) from your network. (The phone requires PoE
Class 1.) If you are not using PoE, install the phone
near a power outlet not controlled by a wall switch.
The phone can be placed on a flat surface
or vertically mounted on the wall.
Avoid placing the deskset too close to:
»
Communication devices such as television sets,
DVD players, or other cordless telephones
»
Excessive heat sources
»
Noise sources such as a window with
traffic outside, motors, microwave ovens,
refrigerators, or fluorescent lighting
»
Excessive dust sources such as a workshop
or garage
»
Excessive moisture
»
Extremely low temperature
»
Mechanical vibration or shock such as on top of
a washing machine or work bench.
1234 Main St | Anycity, US 00000 | 215.555.1212 | www.corporatewebsite.com
To install the phone:
1.
If you plan to place the phone on a flat
surface, attach the stand. Line up the tabs
on the stand with the slots on the rear of the
phone. Two sets of slots allow you to attach
the stand at either a 45-degree or 35-degree
angle. To wall mount the phone, see the
Wall mounting
slots
VSP715 Deskset User Guide.
Power jack
Handset jack
2.
Plug the end of the coiled handset cord into
the Handset jack on the rear of the phone.
Secure the cord by routing it through the slot
and underneath the tab.
3.
Plug one end of the Ethernet cable into the
Ethernet port on the rear of the deskset
(marked by
the cable into your network router or switch.
If the deskset is not using power from a PoE-
capable network router or switch:
»
Connect a power adapter to the deskset
power jack.
»
Plug the power adapter into an electrical outlet
that is not controlled by a wall switch.

IMPORTANT INFORMATION

1.
Use only a compatible VTech power adapter.
To order a power adapter, visit our website
at businessphones.vtech.com or call
1 (888) 370-2006.
2. The power adapter is intended to be correctly
oriented in a vertical or floor mount position.
The prongs are not designed to hold the plug
in place if it is plugged into a ceiling, under-
the-table or cabinet outlet.
If there is a networked computer and no extra
Ethernet wall ports near the phone, then the phone
and PC can share the same network connection.
Quick Reference Guide
Handset jack
Slot and tab
), and plug the other end of
2