Sata Configuration - Supermicro X11SSN-H/-E/-L User Manual

X11SSN-H/-E/-L User's Manual
SATA Configuration
SATA Controller(s)
Use this feature to enable or disable the onboard SATA controller supported by the SoC. The
options are Enabled and Disabled.
*If the feature above is enabled, the following features are available for configuration:
SATA Mode Selection
Use this feature to select the mode for the installed SATA drives. The option is AHCI.
SATA Port 0
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Port 0
Use this feature to enable or disable the specified SATA port. The options are Disabled and
Enabled.
Hot Plug
Set this feature to Enabled for hot plug support, which will allow the user to replace a SATA
drive without shutting down the system The options are Disabled and Enabled.
Spin Up Device
When the value of an edge detect or the value of an image binary (pixel) of a device is from
0 to 1, select Enabled to allow the PCH to start a COMRESET initialization sequence on this
device. The options are Disabled and Enabled.
SATA Device Type
Use this item to specify if the SATA port specified by the user should be connected to a Solid
State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
PCIe/PCI/PnP Configuration

Option ROM execution
Video
Use this feature to select which firmware type to be loaded for the add-on card in this slot.
The options are Do not launch, EFI, and Legacy.
66