Sharp MX-M266N Manual page 24

SD CARD REPLACEMENT PROCEDURE
Replacement Procedure:
When replacing the SD card, be sure to use the specified SD card supplied as a service part only.
The firmware required for booting the MFP device must be included on the SD card that is used in this
machine - Commercially available SD cards do not have this firmware data.
1. Use SIM56-02 to backup the SD card data to the USB memory.
2. When the operation panel home screen has been customised, backup the SD card data by using the
device cloning function.
3. When there is FAX/Internet Fax data received, use SIM66-62 to backup the image data to the USB
memory (PDF file type), and then provide the PDF data to the user. (The data cannot be restored to
the machine.)
4. Replace the SD card with a new one.
5. Upgrade the firmware to the latest version.
6. Use SIM66-10 to clear the image send memory. (This is in order to obtain consistency between
the HDD data and the image related memory.)
7. Use SIM56-02 to restore the data backed up in procedure 1.
8. Restore the data backed up in procedure 2 by using the device cloning function.
Notes:

If E7-07 or U2-40 trouble occurs and the error cannot be cancelled using SIM16, this may indicate
an issue or failure of the SD Card – replace the SD Card by following the procedure detailed
above.

The data backed up with SIM56-2 must not be installed to another machine. If installed, the
system and adjustment data will be overwritten and other issues may be generated.
24
SHARP