Solid-State Drive (Ssd) - HP EliteBook 846 G5 Maintenance And Service Manual

Solid-state drive (SSD)

Description
1 TB, PCIe, NVMe, TLC
512 GB, PCIe, SS, NVMe, TLC
512 GB, PCIe, Gen3×4, Self-encrypting drive (SED), Opal 2, TLC
512 GB, SATA-3, FIPS-140–2, TLC
360 GB, PCIe, NVMe,TLC
256 GB, PCIe, SS, NVMe, TLC
256 GB, PCIe, NVMe, value
256 GB, SATA-3, Opal 2, TLC
128 GB, SATA-3, TLC
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the Phillips M2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive by pulling it away from the connector (2).
NOTE:
Reverse this procedure to install the solid-state drive.
34 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Bottom cover on page
M.2 solid-state drives are designed with notches to prevent incorrect insertion.
32).
Battery on page 45).
Spare part number
L29198-001
L29196-001
L29197-001
L29195-001
L29194-001
L29192-001
L29193-001
L29191-001
L29190-001