Code Identification; Code Identification Chart - RCA RCU1010RF User Manual

Universal learning remote with touchscreen and built-in rf transmitter

Hide thumbs Also See for RCU1010RF:

Quick start manual (5 pages)

Quick start manual (9 pages)

Table of Contents

Available languages

RCU_1010_RF_IB_RevA.qxd

7. The Autosearch sends the next code in the list every three

seconds. The current code being sent is displayed in the upper

right-hand corner.

8. To speed up the Autosearch, you can manually override the

process and temporarily speed it up by pressing the normal

search keys (CH+, CH-, ON•OFF, LCD UP and DOWN

ARROW) in both forward and reverse directions.

9. Once the component to be controlled responds to the

commands, press and release the LCD OK key to save the

code. After you install its code, all key labels and any

previously Learned commands will be reset.

If your component responds to the command, and the

Note:

RCU1010RF sends the next code before you have a chance to

press and release the LCD OK key, you can backtrack through

the Code List by pressing CH- or the LCD DOWN ARROW.

You can change the direction to forward once again by

pressing the ON•OFF, CH+, or LCD UP ARROW keys.

10. After pressing the LCD OK key in step 9, the LCD displays the

Code Search Mode? Screen. Code Autosearch is now complete.

To exit the Setup Mode, press and release the LCD EXIT key,

followed by the LCD OK key on the Exit Setup Screen.