Lincoln Electric K2613-5 Operator's Manual page 15

Process limitations
• GMAW-P procedures must be qualified by the cus-
tomer.
• Across-the-Arc models are not recommended for
stitch or spot welding.
Equipment limitations
• The duty cycle of the wire feeder is 450A, 60%. Duty
cycle is based upon the amount of welding
performed in a 10 minute period.
• The maximum spool size is 45 lb. (24 Kg), 12"
(305mm) diameter.
• Maximum FCAW gun length is 15 ft.
• Maximum GMAW gun length is 25 ft.
• K2330-1 Timer Kits do not work with the feeder. Use
K2330-2 kits.
• Push-pull guns do not work with the LN-25™ PRO.
• Not compatible with K489-7 Euro connector (except
K2614-7,-8)
Recommended power sources
• CV-305
• CV-400
• CV-655
• DC-400
• DC-600
• DC-655
• Invertec V-350
• FlexTec 450
• Multi-Weld 350
• Ranger 10,000
English
• Ranger 3 Phase
• Ranger 225
• Ranger 225 GXT
• Ranger 250
• Ranger 305
• SAE-400
• Pipeliner 200G
• Classic 300
• Vantage 300
• Vantage 400
• Vantage 500
12
(See Customer Assistance Policy in the front of this
Instruction Manual)
Case front controls
(See Figure 9)
A
B
C
D
E
A. ANALOG VOLTMETER
B. WIRE FEED SPEED KNOB
C. WIRE FEED SPEED RANGE SWITCH
D. 5-PIN GUN TRIGGER CONNECTOR
E. WORK SENSE LEAD
F. THERMAL LED, MOTOR OVERLOAD
G. POLARITY LED
Figure 9
Analog voltmeter
Reads 0 – 40 VDC and is polarity insensitive. Shows
OCV when not welding and arc voltage when
welding.
The serviceability of a product or structure utilizing the
LN-25™ PRO wire feeder is and must be the sole
responsibility of the builder/user. Many variables beyond
the control of The Lincoln Electric Company affect the
results obtained in using the LN-25™ PRO wire feeder.
These variables include, but are not limited to, welding
procedure, plate chemistry and temperature, weldment
design, fabrication methods and service requirements.
The available range of the LN-25™ PRO wire feeder
may not be suitable for all applications, and the
builder/user is and must be solely responsible for
welding settings.
F
G
English