Casio SA-5000 Service Manual page 40

7-4-2. BIOS setup operation
To change the BIOS setup menu
1. Turn the mode key to "5" position.
2. Turn the power switch on.
3. Press "5" button when the AMI BIOS screen appears on the LCD display.
4. Then main menu appears on the LCD display.
7-4-3. Main Menu
The main menu is shown below. The standard display device is usually the VGA CRT on which the
BIOS for a IBM PC-AT compatible will display a full menu. However, in order to use the 2X20 VFD
module for CMOS setting, this format has been modified.
1. Serial Port Setup
2. System Setup
3. Reset to Default Values
4. Save & Quit
5. Exit w/o Saving
When the BIOS system setup is entered, the program will display the first two lines of the main menu
on the operator display (2 x 20 VFD), and the cursor on the display should be set to the first line,
first column.
1 S E
2 S Y
When a Down key is pressed in succession, the cursor on the display will move to the first column on
the next line as well as scroll the display as shown below.
↓
Display:
2 S Y
3 R E
↓
Display:
3 R E
4 S A
R I A L P
S T E M S
S T E M S
S E T T O
S E T T O
V E A N D
— 38 —
O R T S S
E T U P
E T U P
D E F A U
D E F A U
E X I T
E T U P
L T S
L T S