Reassembling And Assembling Procedure; Bottom Plate And Plug Connector - Panasonic NC-HU301P Service Manual

4. Reassembling and Assembling Procedure

[Below figure shows the case]
Attention,
Please assemble in the reverse sequence referring to
Assembling points.

4.1. Bottom plate and Plug connector

1. Remove 2 Tapping screws.
2. Remove 2 Truss screw from Body
3. Remove 1 Tapping screw of Plug connector
4. Remove Plug connector and slide insulation sheet A comp.,
and then orange and white lead wires from the Plug connector.
5. Remove insulation sheet A comp. from orange
and white lead wires.
Bottom plate
Truss screw
Sleeve
4x12 Tapping screw
Body
Plug connector
Be careful for injuries by the
end face of metal portions
while reassembling,
replacement and assembling.
Wear groves while working.
4x12 Tapping screw
Fig-1
— 20 —
NC-HU301P, NC-HU401P
Caution