Firebox Entry - Quadra-Fire DV400S Owner's Manual And Installation Instructions

DV400S DIRECT VENT ROOM HEATER

Firebox Entry

A. Removing the Front Face.
1. Loosen the thumb screw from the bottom of the unit that holds
the front face in position. See Figure 16.
2. Carefully lift the front face up and pull the bottom forward.
Place it in a safe place.
Figure 16 - Bottom Thumb Screw
B. Removing the Glass.
3. Remove the glass frame assembly by pulling the latch releas-
es forward and upward. See Figure 17. Lift the glass frame
assembly up, sliding the [3] tabs at the bottom out of the slots.
Figure 17 - Removal of Sealed Glass
1.
3.
2.
Figure 18 - Log Identification
March 4, 2002
C. Log Placement.
The logs are shipped in separate packaging. Refer to
Fig. 18 for identification, and Fig 19, 20, and 21 for the
installation process.
D. Creating the Coal Bed Look.
Ember Chunks
Randomly place the ember chunks on the burner tube
between and in line with the two front logs, creating a small
wall of embers. Do not allow the chunks to cover the
burner ports or air holes in the burner tube as this may
1. Rear Log
restrict air and/or gas flow, creating a less than satisfac-
2. Front Log
tory performance. Too much restriction can cause improp-
3. Top Log
er combustion and sooting (especially with an appliance
using propane gas).
Mineral wool may be bridged over the chunks for greater
enhancement.
Page 23
.
R
Fig. 19
Rear Log
Placement
Fig. 20
Front Log
Placement
Fig. 21
Top Log
Placement
30211C