Operating Procedures; Procedures When Using The Motion Control Function Module - Omron NX-EC0112 User Manual

2-2

Operating Procedures

The operating procedures for the Position Interface Units depend on the system configuration.
For example, even when you use an NJ/NX-series Controller, the operating procedures depend on
whether the MC Function Module is also used.
This section describes the basic operating procedures that are required to use the Units.
2-2-1

Procedures When Using the Motion Control Function Module

This section describes the basic operating procedures that are required to use the MC Function Module
in an NJ/NX-series Controller.
Additional Information
Refer to the NJ/NX-series CPU Unit Motion Control User's Manual (Cat. No. W507) for the
main operating methods.
However, the NJ/NX-series CPU Unit Motion Control User's Manual (Cat. No. W507) is written
based on the assumption that a G5-series Servo Drive or Motor is used. Some of the material
does not apply if you use a Pulse Output Unit.
Refer to 8-9-2 Precautions When Using the Pulse Output Unit on page 8-42 for information on
the differences between when a G5-series Servo Drive or Motor is used and when a Pulse Out-
put Unit is used.
NX-series Position Interface Units User's Manual (W524)
2 Specifications and Application Procedures
2
2 - 3