Feed Forked Connection - Singer 5400 Series Service Manual

Service Manual
Removal:
1
Remove the free arm extension table, tension assembly dial, the knobs of the zig-zag and needle
position levers, all covers (face plate, rear, bottom bed and front), the buttonhole assembly (see
1
pages 5 -52) and the hand wheel.
2- Remove screw nut ( I ) and the eccentric screw (H).
3- Position the top of the eccentric gear at the back of the machine
4- Turn shaft (E) counterclockwise until stitch regulator stroke is in the vertical position and keep it in
that position
5- Remove the fork by pushing it down
Replacement:
1-
Replacement is the same as removal in reverse order.
2- Adjust feed dog throw.(See pages 02- 03)
Rev. n .
o
MAY/00

Feed forked connection

1 1
42
P/N 357773-002