Table Of Contents; Timing Of The Hook - Pfaff 130-6 Instruction Book

2. Timing of ihe Hook
Set zigzag dial on Position 4 (widest stitch). Loosen the
two lock-screws of the hook and take off base stop.
Turn hand wheel until needle bar is on extreme left, and
at the lowest point. Bring the point of the hook around
to the needle. Hold it there and turn hand wheel in direc-
tion of rotation (towards front of machine) until the top
of the eye of the needle is approximately 1/32" below
the bottom of the point of the hook. Bring the hook as
close as possible to the needle without touching the
needle, and lock the hook in position on the hook shaft.
Replace base stop, and push it towards the front of the
machine until you ve got a least 1/32" or more clearance
between the base stop and the base. Now the hook is
timed.
Index
I. Useful hints
.....................
I
II. To oil and clean the machine
2..........2
Ill. The needle ...
.................
6
IV. Feeding
6
1. Threading the needle
.
7
2. To set the needle ..........
....
7
3. To remove bobbin case ....
..........
7
4. To wind the bobbin .....
............
7
5. To replace bobbin case ...........
11
6. To commence sewing .............
.. 11
7. To remove the work ....
............
12
8. To regulate the tension of the upper thread
.
12
9. To regulate the tension of the under thread
.
13
10. To regulate the length of stitch ..........
13
11.
The Dial-A-Stitch
............
14
12. To take apart and clean the hook .......
15
39