Hatco GR Installation And Operating Manual page 13

English
Remote Control Enclosures
Hatco remote control enclosures include switches, wire leads,
and/or indicator lights and are shipped ready for installation.
The RmB Series require one remote control enclosure per strip
heater. The RmB2 Series allows multiple strip heaters to be
connected to one remote control enclosure.
NOTE: Remote control enclosures are available in several
configurations depending on the model. All enclosures
are built in accordance with UL standards to
accommodate switches, indicator lights, and wiring. See
the OPTIONS aND aCCESSORIES section for more
information.
IMPORTANT NOTE:
Remote mounted enclosures and control switches must be
installed in a cool, dry location as far away from any heat zone
as possible. Do not mount enclosures or switches directly on,
under, or above unit. Do not mount enclosures or switches in
direct contact with any heated surface or near any steam
generating equipment.
D O N O T
Form No. GRm-0115
I N S T A L L
E N C L O S
U R E I N T
Remote mounted Enclosure Installation Locations
Remote Mounted Control Switches
Optional remote mounted control switches include ON/OFF
toggle switches and infinite control switches. These switches
need to be installed into an approved electrical box/enclosure
(not supplied) by a qualified electrician. See the OPTIONS aND
aCCESSORIES section for more information.
NOTE: When two or more units are mounted where the heat
from one housing tends to raise the temperature of
another, the control switches should be installed in a
remote control enclosure. Units in a multiple installation
should use remote mounted control switches.
To prevent premature failure of components due to
excessive heat, remote mounted control switches must be
installed outside the strip heater heat zone.
Heat
H I S A R E A
Mounting
Screw
13
INSTALLATION
NOTICE
Mounting
Flange