Bosch BMS500-AAU009-0AHXXA Service Manual page 53

Service Manual
9.1.7 How to Remove the Chassis assembly
CAUTION:
Because the 24K indoor unit is relatively large and heavy, it
must have two persons to implement the following steps.
Step1: Remove the left and right pipe cover.
Step2: Remove the 5 screws A,B,C,D,E remove support part F and G
(Fig.70).
Figure 52
Screw E is behind the E-box by mistake for this sample, you need to
remove screw X, to lift the E-box a little, Then you can remove the Screw E.
Bosch Thermotechnology Corp. | 02.2018
Bosch Climate 5000 AA Series Split Type Ductless Air Conditioner / Heat Pump | 53
Step3: Open the E-box (Fig. 71), to loosen the fan motor and louver motor
connectors from the PCB.
Step4: Press the locker H and I , to lose the indoor from the installation
plate, lift it a little and pull it out along the direction indicated in Fig. 71.
Figure 53
It is not necessary to remove the panel to remove the Chassis assembly, in
order to show clearly inside, these pictures are without panel.
Data subject to change