Omron C200HW-PRM21 Operation Manuals page 54

Operation
Slave Parameter Data
38
Depending on the type of slave, specific parameter information may need to
be transferred to the slave at initialisation. The 'Parameter Data' dialog box
allows verification and adjustment of these parameters in several ways.
The initial dialog shows all parameter data in hexadecimal notation. A
thorough understanding of the device is required to modify the parameters
through this panel in a safe way. When in doubt, leave these values at the
defaults, which SyCon reads from the GSD file.
If the GSD file provides additional information for parameter adjustment, the
buttons 'Common' and/or 'Module' will be accessible.
'Common' provides access to the parameters which control the slave as a
whole, i.e. which are not specific for a module.
'Module' will allow the parameters for a specific module to be adjusted, e.g.
In the example shown, all German texts have been read from the device's
GSD file. Please check with the slave manufacturer for the availability of files
in other languages.
All module assignments and parameter settings will be saved in the
configuration file, and need to be downloaded to the Master Unit. After the
download the Master will restart the network, and transfer the settings to the
slaves. The configuration and parameter settings cannot be changed online,
while the master is in data exchange mode.
Section 4-3