Table of Contents
Advertisement
Testing Your System
Device
Takeover
Module
(SW-ATT-
TAKRF)
Digital Life User Manual
Procedure
• DLS in
Test/Maintenance
Mode
Note: The Takeover
Module can be utilized to
re-use the existing wired
door/window sensors in
your home. In order to
test the Takeover Module,
you can open the wired
door/window sensors one
at a time.
End-to-End Testing
• Test each existing
wired door/window
sensor one at a time by
executing the following
procedure:
o Arm the system in
the Armed-STAY
Mode
o Open one protected
door or window
o After the alarm has
been observed,
enter your Alarm
Panel PIN to cancel
the alarm and then
enter your Alarm
Panel PIN again to
clear the message
|
Page 62 of 62
Results
End-to-End Testing
• For each existing wired
door/window sensor
• Keypad LCD will display:
<Device Name> -
Opened (For example,
"Master Bedroom
Window - Opened")
• Keypad LCD will display:
Intrusion Alarm Sent
• Keypad LCD will
Display: Alarm – Enter
PIN to Cancel
• Keypad LCD will display:
Alarm Canceled
• Keypad LCD will display:
Enter PIN to Clear
Notes
• An Intrusion alarm
has been sent to
AT&T Digital Life
Central Monitoring
Center with no
action required
ATT-UM-V1.1-201303
Hide quick links:
Advertisement
Table of Contents
