AT&T DLC-100 User Manual page 63

Testing Your System
Device
Recessed
Door /Window
Sensor
(SW-ATT-
RDW)
Motion Sensor
(SW-ATT-PIR)
Digital Life User Manual
Procedure
o Open one protected
door or window
o After the alarm has
been observed, enter
your Alarm Panel PIN
to cancel the alarm
and then enter your
Alarm Panel PIN
again to clear the
message
• DLS in Test Mode
End-to-End Testing
• Test each device one at
a time by executing the
following procedure:
o Arm the system in
the Armed-STAY
Mode
o Open one protected
door or window
o After the alarm has
been observed,
enter your Alarm
Panel PIN to cancel
the alarm and then
enter your Alarm
Panel PIN again to
clear the message
• DLS in Test Mode
|
Page 53 of 62
Results
• Keypad LCD will
Display: Alarm – Enter
PIN to Cancel
• Keypad LCD will display:
Alarm Canceled
• Keypad LCD will display:
Enter PIN to Clear
End-to-End Testing
• For each device
• Keypad LCD will display:
<Device Name> -
Opened (For example,
"Kitchen Door -
Opened")
• Keypad LCD will display:
Intrusion Alarm Sent
• Keypad LCD will
Display: Alarm – Enter
PIN to Cancel
• Keypad LCD will display:
Alarm Canceled
• Keypad LCD will display:
Enter PIN to Clear
End-to-End Testing
• For each device
Notes
• An Intrusion alarm
has been sent to
AT&T Digital Life
Central Monitoring
Center with no
action required
• There is a three (3)
minute delay
between
ATT-UM-V1.1-201303