Vhf Antenna Connection; Vhf Antenna Requirements; Vhf Radio Connection; Silent Mode Switch Connection - Raymarine AIS700 Installation Instructions Manual

4.7 VHF antenna connection

Connect a VHF antenna (not supplied) to your AIS700
using the VHF antenna connection.

VHF antenna requirements

The VHF antenna should meet the following
requirements:
Frequency band 156.025 MHz to 162.025
MHz
VSWR (Voltage Standing should not exceed 2:1
Wave Ratio
Impedance 50 Ohm
Gain 3dBi Max
Connector PL-259
24

4.8 VHF radio connection

For systems that include a VHF DSC radio you can
share the VHF antenna by connecting your Radio's VHF
antenna connection to the VHF Radio connection on
your AIS700 and then connecting your VHF antenna to
the AIS700,s VHF antenna connection.
4.9 Silent mode switch
connection
In Silent mode your AIS700 will stop transmitting position
data and operate as a receiver only. Silent mode can be
enabled using a connected MFD and by connecting a
switch to the relevant wires on the Power/data cable.
Please refer to your MFD's operation instructions for
details on enabling silent mode.
Note: A silent mode switch will override an MFD's
Silent mode setting.
1. Power/data cable (supplied)
2. Light Green wire
3. Orange wire
4. Switch (not supplied)
Crimp or solder wire connections and ensure suitable
insulation from water ingress.