Control - THUNDER TIGER TTR4572 Assembly Manual

W W I I N N G G A A S S S S E E M M B B L L Y Y
7. Remove the covering at the holes and epoxy
two dowels all the way in.
8. Remove the covering by a hobby knife at the
aileron servo well.
9. Thread the servo wire through wing panels and
exit at the servo wire exit hole. If you use a
standard 4ch radio then you will need a "Y"
style extension wire. Tape the connectors to
prevent from loosening. If you use a quality
programmable radio then we suggest you to use
two 10" long servo extension wires and turn on
the function of "Flapron" or Aileron-Flap
mixture control.
2
10.Locate the control horns. Install the control
horn as shown. There are 5 cleveises in the
parts bag and a special clevis which has larger
pushrod hole that is for rudder pushrod. Use
the clevis with small hole in this step.
M2
11. Place the control horn on the aileron with
aileron pushrod(M) installed. Drill 5/64"
(2mm) holes.
2mm
8
25cm
Flapron
2x14mm