•
Two dedicated 10G/1G SFP+ ports.
•
One USB port to support firmware upgrades from a disk and backups to a storage device.
•
Full NETGEAR Smart Switch functionality.
•
Full compatibility with IEEE standards:
-
IEEE 802.3i (10BASE-T)
-
IEEE 802.3u (100BASE-TX)
-
IEEE 802.3ab (1000BASE-T)
-
IEEE 802.3an (10GBASE-T)
-
IEEE 802.3z (1000BASE-X)
-
IEEE 802.3 Clause 49 (10GBASE-LR and 10GBASE-SR)
-
IEEE802.aq (10GBASE-LRM)
-
IEEE802.3ae (10GBASE Ethernet)
-
IEEE802.3az (Energy Efficient Ethernet)
-
IEEE 802.3x (Full-duplex flow control)
-
IEEE 802.1at (PoE+)
•
AutoSensing and autonegotiating capabilities for all ports.
•
Auto Uplink technology is supported on all ports.
•
Automatic address learning function to build the packet-forwarding information table. The
table contains up to 16K Media Access Control (MAC) addresses.
•
Store-and-forward transmission to remove bad packets from the network.
•
Full-duplex IEEE 802.3x pause frame flow control.
•
Active flow control to minimize packet loss and frame drops.
•
Half-duplex backpressure control.
•
Per-port status LEDs and system status LEDs.
•
Internal open frame power supply.
•
Standard NETGEAR chassis (1U high).
•
NETGEAR green power-saving features:
-
Energy efficiency mode that fully conforms to the IEEE802.3az standard
-
Per-port automatic change to a lower power mode when the port link is down
•
Support for Power over Ethernet (PoE+) on models S3300-52X-PoE+ and
S3300-28X-PoE+.
•
Support for an RPS4000 external power supply to provide a larger power budget for
model S3300-52X-PoE+ or model S3300-28X-PoE+.
S3300 Smart Switch
Introduction
7