Stopping Transmission - Fujitsu LifeBook T3010 Manual

of software to be used, installation status, radio-
wave status, or other operating conditions.
Decreases in communications speed or a
communications failure may also occur.
• Distance the main unit of this personal computer
is from other electric appliances. If the main unit
of the person computer is installed near a
powered-on electric appliance, the computer
may not be able to communicate properly or
trouble may occur in the electric appliance.
• If the computer is unable to communicate
properly, change the channel to be used or the
installation location. During the use of a
microwave oven or other equipment generating
strong high-frequency energy, in particular, the
personal computer may be highly susceptible
to the energy and unable to communicate
properly.
• If a broadcasting station or wireless
communications equipment is present nearby
and this prevents the computer from
communicating properly, moving the main unit
of the computer is suggested. Radio
interference may also occur if the intensity of
ambient radio waves is too high.

Stopping Transmission

To use this product inside hospitals, clinics, or
airplanes, or in other places where the use of
electronic equipment is regulated, stop the
transmission of radio waves from the wireless
LAN beforehand.
Deactivation using the wireless switch
The transmission of radio waves from the
wireless LAN can be stopped by setting the
wireless switch to the Off position. Note that the
Wireless LAN On/Off switch has no effect on non-
Wireless LAN models.
Wireless LAN User's Guide
Wireless LAN
On/Off Switch
Figure 3. Wireless LAN On/Off Switch
Deactivation using Windows
Intel PROSet Wireless LAN:
1. Click [Start] → [(All) Programs] → [Intel
Network Adapters] → [Intel(R) PROSet]. The
Intel(R) PROSet window will be displayed.
2. Click the General tab.
3. Select [Off] for the wireless communications
Switch Radio: function, and then click the [OK]
button. Wireless communications on/off
switching will be deactivated and the
transmission of radio waves from the wireless
LAN will be stopped.
To restart transmission, select [On] for the
wireless communications Switch Radio:
function, and then click the [OK] button.
Broadcom Wireless LAN
1. Click [Start] → [Control Panel] → [Broadcom
Wireless Utility]. The Broadcom Wireless
Configuration Utility window will be displayed.
2. Click the Wireless Networks tab.
3. Click the [Enable Radio] box to clear it, then
click the [OK] button. Wireless communications
on/off switching will be deactivated and the
transmission of radio waves from the wireless
LAN will be stopped.
To restart transmission, check the [Enable
Radio] checkbox to select it., then click the
[OK] button.
73