Fujitsu LifeBook T3010 Manual page 71

Problem
Video Problems
The built-in The angle of the display
display is blank and the brightness
when you turn on settings are not adequate
your Tablet PC. for your lighting
conditions.
The optional Port
Replicator is attached, an
external monitor is
plugged in, and the Tablet
PC is set for an external
monitor only.
The power management
timeouts may be set for
very short intervals and
you failed to notice the
display come on and go
off again.
Power On Self Test
The Tablet PC
(POST) has detected a
turned on with a
failure which does not
series of beeps
allow the display to
and your built-in
operate.
display is blank.
The system may be
Your system display
password-protected.
won't turn on when
the system is turned
on or when the
system has resumed.
The Tablet PC has gone
The display goes
into Video Timeout,
blank by itself after
Standby Mode, or
you have been
Hibernate Mode because
using it.
you have not used it for a
period of time.
The power management
timeouts may be set for
very short intervals and
you failed to notice the
display come on and go
off again.
Possible Cause
Tr o u b l e s h o o t i n g
Possible Solution
Move the display and the brightness control
until you have adequate visibility.
Pressing [F10] while holding down the [Fn] key
allows you to change your selection of where
to send your display video. Each time you
press the combination of keys you will step to
the next choice. The choices, in order are:
built-in display only, external monitor only, both
built-in display and external monitor.
Press any button the keyboard, or move the
mouse to restore operation. If that fails, push
the Suspend/Resume button. (The display
may be shut off by Standy mode, Auto
Suspend or Video Timeout).
Contact your support representative.
Check the status indicator panel to verify that
the Security icon is blinking. If it is blinking,
enter your password.
Press any button on the keyboard, or move
the mouse to restore operation. If that fails,
push the Suspend/Resume button. Check your
power management settings, or close your
applications and go to the Power Savings
menu of the setup utility to adjust the timeout
values to better suit your operation needs.
Press any button on the keyboard, or move
the mouse to restore operation. If that fails,
push the Suspend/Resume button. (The
display may be shut off by Standby Mode,
Auto Suspend or Video Timeout).
59